SCCM Client – Manual install and uninstallblog.jocha.se/tech/sccm-client-install-uninstall There are several scenarios where you would need to manually install or uninstall the SCCM agent/client, and here’s a quick guide how to do it! Manual Installation The SCCM 2012 client is stored on your SCCM server (or additional Management Points) in the Client-folder under SMS_SITECODE (\\SCCMSERVER\SMS_SITECODE\Client\). You can run the setup using syntax or just simply use the GUI to choose your settings after installation. If you prefer the scripty way use: ccmsetup.exe /mp:SCCMSERVER /logon SMSSITECODE=AUTO You can read more about the setup commands at TechNet. Or Run ccmsetup.exe, when the client is installed go to Control Panel, press Configuration Manager. Go to the Site-tab, press Configure Settings to elevate the window and then press Find Site. Make sure the proper site name shows up and then press OK. The client will now download and apply your client policies. 1/3 Uninstall Uninstalling the client is pretty straight forward. Open a command prompt (elevated privileges). Write: C:\Windows\ccmsetup\ccmsetup.exe /uninstall Installation Error Codes: 2 – The system cannot find the file specified. 2/3 2 – The system cannot find the file specified. 5 – Access denied. 52 – You were not connected because a duplicate name exists on the network. Make sure there is not a duplicate name in DNS and that 2 machines don’t have the same IP in DNS. 53 – Unable to locate – http://support.microsoft.com/kb/920852 – cannot connect to admin$ – Computer Browser not started – add File/print sharing to Exceptions in Firewall – turn file and print on. 58 – The specified server cannot perform The requested operation 64 – The specified network name is no longer available. Source: Windows 67 – network name cannot be found. 86 – network password is not correct? Machine Name <> resolved name. 112 – Not enough disk space 1003 – Cannot complete this function. 1053 – The service did not respond to the start or control request in a timely fashion. 1068 – The dependency service or group failed to start 1130 – Not enough server storage is available to process this command. Source: Windows 1203 – The network path was either typed incorrectly, does not exist, or the network provider is not currently available. Please try retyping the path or contact your network administrator. 1208 – An extended error has occurred. Source: Windows 1396 – Logon Failure: The target account name is incorrect. (NBTSTAT -a reverse lookup, duplicate IP address) 1450 – Insufficient system resources exist to complete the requested service. Source: Windows 2147749889 – Generic WMI failure (Broken WMI) 2147749890 – not found – Source: Windows Management (WMI) – try repair WMI 2147749904 – Invalid class – Source: Windows Management (WMI) 2147749908 – Initialization failure – Source: Windows Management (WMI) 2147942405 – Access is Denied (Firewall rule? / MacAfee-HIPS?) 2147944122 – The RPC server is unavailable. (Dcom is miss-configured for security . http://support.microsoft.com/kb/899965 ) 2148007941 – Server Execution Failed 3/3
Report "Blog.jocha.se-sCCM Client Manual Install and Uninstall (1) (1)"